Robust Wind Generator Original IstaBreeze® L-500
Manufactured from fiberglass reinforced plastic, the blades and housing are durable, stable and unusually lightweight.
The maintenance-free sliding contact (without coal) guarantees a good flow of current and thus no twisting of the cable in the mast.
Installation in the mast tube by plug connection. Required mast tube inside diameter: 37 mm nominal dimension!
Can also be used in combination with photovoltaic solar cells with our hybrid charge controllers.
This IstaBreeze® 650 Wind / Solar Hybrid Charge Controller is for parallel use
from 3-phase generators (AC) to max. 500 watts
and 2-phase photovoltaic modules (DC) up to max. 150 watts suitable.
- Available in two versions: 12 Volt or 24 Volt
- Microchip controlled
- Aluminum casing
- LEDs for display: charging / battery connected / battery full
- Control the charging process to protect the battery from overcharging
- Braking the wind generator at too high wind speeds
This makes it possible to use wind generator power and solar module power for charging batteries.
Tower Specifications:
4 meters IstaBreeze® TOWER for wind generator i 500, L-500, IstaBreeze® or wind generators up to 15 KG
It has never been so easy to install a wind generator.
With the IstaBreeze® Tower it is possible to build a wind generator in a few minutes.
The folding system simplifies the whole process.
During maintenance, only a few screws are released and the tower can be folded for maintenance.
The mast can be extended by a maximum of 2 meters!
Dowels and screws for the floor (concrete floor) is still needed !!
Diameter of the mast is 42 mm
Inner hole, connector wind generator .......... 37 mm
Optional The vibration damper for the wind generators i-500- L-500 and i-700 to i-2000, reduces the transmission of structure-borne noise from the wind generator into the mast and thus possibly into the house. The retrofit is very simple, because the body silencer has the same dimensions as the wind generator, it must only be inserted between them and screwed with the appropriate screws on the mast and the wind generator.
The vibration damper is compatible with our original IstaBreeze® masts 15kg and 40kg.
System Voltage:12V or 24V
Rated Capacity:400W
Max Performance:500W
Current:35A (12V) / 18A (24V)
Noise:40 dB
Nominal Battery Voltage:12V /24V
Charging Current Amperes Max. Wind:35A (12V) / 18A (24V)
Min Battery Voltage:9V (12V) / 18V (24V)
Brake Function (mechanical short circuit, wind turbine is short-circuited by relays until the complete style level is reached):From 14.9V (12V) / 29,6V (24V)
Min Recommended Battery:Gel
Blade Material:Composite
Blade Length:60 cm
Rotor Diameter:122 cm
You can see manual book for charge controller here: https://www.altinelenerji.net/english-manual-book/650W-850W-Hybrid-Charge-Controller-Manual-Book.pdf
YOU CAN SEE CONNECTION SCHEMA -->
