Robust wind generator original IstaBreeze® i-700 / 12V in set.
Due to the production of glass fiber reinforced plastic, the rotor blades are very durable and stable, at the same time unusually light. The housing is made of aluminum, which guarantees optimal cooling of the generator.
The maintenance-free sliding contact (without coal) guarantees a good flow of current and thus no twisting of the cable in the mast.
Installation in mast tube by plug connection. Required mast tube nominal diameter: 37mm nominal size!
The Wind / Solar hybrid charge controller from IstaBreeze® is an intelligent controller of the wind turbine and the solar cells that controls you at the same time. The high-end device thus controls your island system. It is used to safely and efficiently charge and control your battery with the Wind Generator / Solar Module combination.
With its discreet appearance, simple operation, with integrated protection functions, this device has high efficiency and low no-load losses. This version of the controller will significantly increase the life and stability of the whole system, especially the batteries.
The special features and product information are listed below:
- Use of solid state components. Increasing the life of the controller.
- Microprocessor controlled charge with integrated voltage and current limiting.
- Electromagnetic brake control, the generator is automatically braked gently when the battery is full, modern braking system in three steps to avoid immediate blockage of the turbine. Increasing the life of the stator.
- Protection against overcharging, deep discharge, short circuit, overload and against incorrect reverse polarity.
Material: Plastic + 30% glass fibers
Length of per blade: 90 cm
Noise: 40 dB
Weight of per blade: 620 g
Rotor Diameter: 190 cm
4 meters IstaBreeze® TOWER for wind generator i-700 to i-2000,
(our WindSafe models require an adapter)
It has never been so easy to install a wind generator.
With the IstaBreeze® Tower it is possible to build a wind generator in a few minutes.
The folding system simplifies the whole process.
During maintenance, only a few screws are released and the tower can be folded for maintenance.
The mast can be extended by a maximum of 2 meters!
Dowels and screws for the floor (concrete floor) is still needed !!
Diameter of the mast is: 60 mm
Inner hole, plug connection Wind generator IstaBreeze® .......... 37 mm
Optional The vibration damper for the wind generators i-500- L-500 and i-700 to i-2000, reduces the transmission of structure-borne noise from the wind generator into the mast and thus possibly into the house. The retrofit is very simple, because the body silencer has the same dimensions as the wind generator, it must only be inserted between them and screwed with matching screws on the mast and the wind generator. (Not for WindSafe models)
The vibration damper is compatible with our original IstaBreeze® masts 15kg and 40kg.