Hybrid Charge Controller 48V 2000W for Wind Turbine Generator

(No reviews yet) Write a Review
Immediate shipment upon receipt of payment until 2 pm o'clock
Minimum Purchase:
1 unit
Nominal Battery Voltage:
48 VDC
Maximum Input Power Wind Turbine:
2 KW
Charging Voltage:



The Wind / Solar Hybrid Charge Controller from IstaBreeze® is an intelligent controller of the wind turbine and solar cells that controls you at the same time. The high-end device can also be used as a monitoring system. It is used to safely and efficiently charge and control your battery with the Wind Generator / Solar Module combination.

With its discreet appearance, simple operation, with integrated protection functions, this device has high efficiency and low no-load losses. This version of the controller will significantly increase the life and stability of the whole system, especially the batteries.

In addition, the control electronics in the control cabinet monitors system voltage and brakes the wind turbine when reaching a max. Overvoltage.


The special features and product information are listed below:

Use of external and high quality (Triacs & Hyper Mosfet), solid state components. Increasing the life of the controller.

Microprocessor controlled charge with integrated voltage and current limiting.

Electromagnetic brake control.

Integrated 3-phase short-circuit switches (brake switch)

Protection against lightning strikes.

Protection against overcharging, deep discharge, short circuit, overload and against incorrect reverse polarity.

Integrated display.

The generator is automatically braked gently when the battery is full, modern braking system with external load resistance (Dump Load) to avoid immediate blockage of the turbine. Increasing the life of the stator.




  • Battery voltage minimum: 42V
  • Cable: 10 qmm screw terminals
  • Charging current PV Ampere max.: 10 A
  • Charging current wind amperes max.: 33 A
  • Charging voltage: 52,8V
  • Cooling: External aluminum cooling fins
  • Display: LCD with 6 displays Amper, Watts, RPM, battery voltage, volts, temperature.
  • (Optional) Dump Load: 2.0 KW braking resistor (3.6 ohms)
  • The load resistor can deviate from the picture. Integrated manual stop switch maintenance protection class IP20 (inside area)
  • Nominal Battery Voltage: 48 VDC Max.
  • Input Power of Wind Turbine: 2,0 KW Max.
  • Input Power of PV Module: 300W
  • Braking function: (electromagnetic short-circuit, ) From 59,4V
  • Operating temperature: Normal: 20~+55°C/35~85%RH Industrial: 30~+55°C/35~85%RH Temperature Compensation -4mV°C/2V, -35°C-- +80°C, Accuracy: ±1°C
  • Measurements: LxWxH 300x400x200mm
  • Weight: 6,5 kg
  • Recommended Battery Min.: Acid & gel




CONNECTION SCHEMA please click here


INSTRUCTION BOOK please click here


2 Year Warranty